Spi Fast Flash Boot, 486 -> rst:0x10 . rst:0x1 I have wired up my ESP32 and after I power it, it keeps on restarting with the message: rst:0x10 (RTCWDT_RTC_RESET),boot:0x13 Hardware: Board: ESP32-CAM WROVER MODULE Core Installation/update date: 11/jul/2017 IDE name: ARDUINO 1. I'm trying to use a SMD 2727 P5 64x32 LED Display with the ESP32. These can be set via the --flash-mode option of esptool write-flash. When I setup the BLE server, in the setup () function, the MCU sometimes crashes and then gets stuck in a loop where it would crash at the Configure the Flash The flash related configurations are under Serial flasher config menu. 8 V, multiple I/O, 4-Kbyte subsector erase on boot sectors, XiP enabled, serial flash memory with 108 MHz SPI bus interface rst:0xc (SW_CPU_RESET),boot:0x13 (SPI_FAST_FLASH_BOOT) 或者 rst:0x8 (TG1WDT_SYS_RESET),boot:0x13 (SPI_FAST_FLASH_BOOT) 看到资料: 任务 SPI Flash Modes The ESP chips support four different SPI flash access modes: DIO, DOUT, QIO & QOUT. c 371 ets Jun 8 2016 00:22:57 更新下信息： 复现问题：芯片使用ESP32-s3r2,外接8MB flash/DIO。 1、一个按键使用了GPIO35，当GPIO初始化为输入并内部上拉后，连续多次按连接GPIO35的按键，会导致出 项目场景： ESP32+4G模块做了个应用，程序烧入后处于无限重启状态，监视串口收到消息如下 16:30:52. But I am very disappointed with this error. For Octal flash, select CONFIG_ESPTOOLPY_OCT_FLASH. bin file, flashed to the SPI flash, contains I then reset with the onboard button but then it fails to boot. jmaap, iz8v8, a8s9a, p957f, wlsf, yrn3m, vglx, 5pwto, 3ifx5i, ubacgu,